Super Speed USB Controller
Device Controller
 

ASM1074

Engaged in Gigabit Data transfer Speed I/O solution development, Asmedia Technology is committed to enlarging product portfolio with introducing USB3.0 HUB controller Products. The ASM1074, the four downstream ports USB3.0 HUB Controller, highly integrated with ASMedia SuperSpeed USB3.0 and USB2.0 self-design PHYs, enables high speed PHY interface up to 5Gbps, following Universal Series Bus 3.0 Revision 1.0 Specification, supporting battery charge for portable device, following battery charge Revision 1.2.

- USB3.0 HUB Features

* Universal series Bus 3.0 Revision 1.0 Compliance
* Upstream Port support SuperSpeed, High-Speed and Full-Speed Connections
* Four Downstream Ports support SuperSpeed, High-Speed, Full-Speed and
   Low-Speed Connections
* Implement USB3.0 power management function
* SuperSpeed Link Power Management support
* USB2.0 Link Power Management support
* USB Attached SCSI Protocol Revision 1.0 Compliance
* Multiple Transaction Translator support
* Port Power Switching and Over-Current Protection per port control
* Individual and Gang mode selectable via strapping
* Remarkable with Removable or permanently attached

- Battery Charge Features

* Support Battery Charge function for portable device, like Cellphone and Pad
* Dedicated Charge Port (DCP) support
* Battery Charge Rev1.2 specification Compliance
* Automatic Battery Charge function detection
* Support the charge function while the system enters active or suspend state

- General Feature

* Integrated 8-bit RISC microprocessor
* SPI flash support for customized firmware
* I2C EEPROM support for customized configuration
* Uploadable Firmware & configuration via upstream port
* Integrated 5V to 3.3V linear regulator
* Self-power and bus-power support
* Automatic power type detection and dynamic power type switch
* Support 20MHz or 25MHz or 30MHz crystal or 48MHz clock input from external  
   clock generator
* IO power supply with 3.3V+/-0.3V & Core power supply 1.05V+/-0.05V
 
   

ASM1054

 

ASM1054 is the new single chip solution to bridge both SuperSpeed USB (USB3.0) and High Speed USB (USB2.0) to Serial ATA with smaller package 5x5 mm2 QFN40, suitable for ultra slim form factor. It is highly integrated with ASMedia SuperSpeed USB3.0, High Speed USB2.0 and SATA1.5/3.0 Gbps self-design PHYs. Customers can easily enhaced their storage device performace via ASM1054 since ASM1054 also integrated CPU and embedded RAM to provide a leading edge solution in USB to SATA device enclosure market.  

 -Feature

*Compliant with USB3.0 Specification Revision 1.0
*Compliant with USB Specification Revision 2.0
*Support USB Super-Speed, High-Speed and Full-Speed Operation
*Support USB Mass Storage Class, Bulk-Only Transport Specification Revision 1.3
*Support USB Attach SCSI Protocol Transport Specification
*Compliance with Serial ATA Specification Revision 2.6
*Support ATA/ATAPI Packet Command Set
*Support ATA/ATAPI LBA48 addressing mode
*Support 20MHz External Crystal
*Support I2C NVRAM for Vender Specific VID/PID of USB Device Controller
*Support SPI NVRAM for Vender Specific Application of USB Device Controller
*Support multi-GPIO pins 

 
 
   

ASM1053 - 3G/6G

ASM1053 is the ASMedia 2nd generation single chip solution to bridge the SuperSpeed USB (USB3.0) and High Speed USB (USB2.0) to Serial ATA host interface, embedding 8-bit microprocessor, integrating voltage regulators and spread spectrum control, enhancing the performance, supporting newest USB Attached SCSI Protocol specification.

ASM1053 splits to two products: One is ASM1053 which supports Series ATA 1.5/3.0 Gbps and the other is ASM1053E integrated with ASMedia Series ATA 6 Gbps PHY.

Like ASM1051, ASM1053E has best USB host and SATA device compatibility and practice various specific application, it also improves the power consumption and benchmark performance and integrates more feature to save the BOM cost. ASM1053 is not only to succeed advantage of ASM1051 but also to be the most cost efficiency and best solution.

 -  Features

* Compliant with USB3.0 Specification Revision 1.0
* Compliant with USB Specification Revision 2.0
* Support USB Super-Speed, High-Speed and Full-Speed Operation
* Support USB Mass Storage Class, Bulk-Only Transport Specification Revision 1.3
* Support UAS Attached SCSI Protocol Specification Revision 1.0
* Compliance with Serial ATA Specification Revision 3.0
* Serial ATA bus up to 6Gbps Signal bandwidth
* Support Spread Spectrum Control of USB3.0 and SATA interface to improve the
   EMI performance
* Integrated 8-bit micro-processor with embedded program RAM and ROM
* Support SPI NVRAM for Vender Specific Application of USB Device Controller
* Support 20/25/30MHz with external crystal mode or 30MHz with Clock input mode
   via strapping
* Integrated internal 5V to 3.3V and 3.3V to 1.2V voltage regulator
* Support 3.3V IO power and 1.2V core power
    
 
   

ASM1051

ASM1051 is the single chip solution to bridge both SuperSpeed USB (USB3.0) and High Speed USB (USB2.0) to Serial ATA. It is highly integrated with ASMedia SuperSpeed USB3.0, High Speed USB2.0 and SATA1.5/3.0Gbps self-design PHYs. With ASM1051 customers can easily enhaced their storage device performace since this product integrated CPU and embedded RAM to provide a leading edge solution in USB to SATA device enclosure market.

- Features

* Compliant with USB3.0 Specification Revision 1.0
* Compliant with USB Specification Revision 2.0
* Support USB Super-Speed, High-Speed and Full-Speed Operation
* Bus bandwidth of USB up to 5Gbps
* Support USB Mass Storage Class, Bulk-Only Transport Specification Revision 1.3
* Compliance with Serial ATA Specification Revision 2.6
* Bus bandwidth of Serial ATA up to 3Gbps
* Support ATA/ATAPI Packet Command Set
* Support ATA/ATAPI LBA48 addressing mode
* Support 20MHz External Crystal
* Support I2C NVRAM for Vender Specific VID/PID of USB Device Controller
* Support SPI NVRAM for Vender Specific Application of USB Device Controller
* Support up to multi-GPIO pins
* Integrated 3.3V to 1.2V Voltage Regulator
* HBM ESD 2.5KV

- Package Type

* Green Package QFN 48L (Pb-Free)
 
   

ASM1051E

ASM1051E is the single chip solution to bridge both SuperSpeed USB (USB 3.0) and HighSpeed USB (USB 2.0) to Serial ATA. It is highly integrated with ASMedia SuperSpeed USB 3.0, HighSpeed USB 2.0 and SATA1.5/3.0/6.0 Gbps self-design PHYs. With ASM1051E, customers can easily enhance their storage device performace by utilizing the integrated CPU and embedded RAM to provide a leading solution in USB to SATA device enclosure market.

- Features

* Compliant with USB3.0 Specification Revision 1.0
* Compliant with USB Specification Revision 2.0
* Support USB Super-Speed, High-Speed and Full-Speed Operation
* Bus bandwidth of USB up to 5Gbps
* Support USB Mass Storage Class, Bulk-Only Transport Specification Revision 1.3
* Compliance with USB Attached SCSI Protocol
* Bus bandwidth of Serial ATA up to 6Gbps
* Support ATA/ATAPI Packet Command Set
* Support ATA/ATAPI LBA48 addressing mode
* Support 20MHz External Crystal
* Support I2C NVRAM for Vender Specific VID/PID of USB Device Controller
* Support SPI NVRAM for Vender Specific Application of USB Device Controller
* Support up to multi-GPIO pins
* Integrated 3.3V to 1.2V Voltage Regulator
* HBM ESD 2.5KV

- Package Type

* Green Package QFN 48L (Pb-free)

- Availability

* ASM1051E will continue to be available for order until Dec. 2013
 
   

ASM1051U

(Discontinued; ASM1051E has been substitute for ASM1051U)

ASM1051U is the single chip solution to bridge both SuperSpeed USB (USB3.0) and High Speed USB (USB2.0) to Serial ATA. It is highly integrated with ASMedia SuperSpeed USB3.0, High Speed USB2.0 and SATA1.5/3.0 Gbps self-design PHYs, and support UAS protocol Transport to enhance the storage performance. Customers can easily enhaced their storage device performace via ASM1051 since ASM1051 also integrated CPU and embedded RAM to provide a leading edge solution in USB to SATA device enclosure market.

- Feature

 

* Compliant with USB3.0 Specification Revision 1.0
* Compliant with USB Specification Revision 2.0
* Support USB Super-Speed, High-Speed and Full-Speed Operation
* Support USB Mass Storage Class, Bulk-Only Transport Specification Revision 1.3
* Compliant with USB Attached SCSI Protocol Rev.0.8a
* Compliance with Serial ATA Specification Revision 2.6
* Support Native Command Queue
* Support ATA/ATAPI Packet Command Set
* Support ATA/ATAPI LBA48 addressing mode
* Support 20MHz External Crystal
* Integrated internal 3.3V to 1.2V voltage regulator
* Support I2C NVRAM for Vender Specific VID/PID of USB Device Controller
* Support SPI NVRAM for Vender Specific Application of USB Device Controller
* Support multi-GPIO pins
* HBM ESD 2.5KV

 

 

 

 
 
   
Host Controller
 

ASM1042

The ASMedia ASM1042 is the Universal Serial Bus 3.0 extended host controller, complies with Intel’s eXtensible Host Controller Interface (xHCI).  ASM1042 is highly integrated with ASMedia PCI Express, SuperSpeed USB3.0, High Speed USB2.0 self-design PHYs, applied for SuperSpeed USB host PC system through PCI Express Bus Interface
The ASMedia ASM1042 SuperSpeed USB Host Controller is designed for high speed and low power data transmit. It also support backwards compatibility with current USB2.0 standard, being used in the PC, mobile, consumer and communication application

 -  Features
      * Compliant with USB3.0 Specification Revision 1.0
      * Compliant with USB Specification Revision 2.0
      * Compliant with xHCI specification Revision 0.96
      * Support USB Super-Speed, High-Speed and Full-Speed Operation
      * Compliance with PCI Express Specification Revision 2.0
      * Compliant with PCI Bus Power Management Interface Specification Revision 1,2
      * Complinat with PCI ExpressCard Revision 1.0
      * Support Seral Peripheral Interface type ROM
      * Support Crystal Clock 20MHz
      * 3.3V and 1.2V power supply
      * HBM ESD > 4KV

 -  Package: TQFN 64L
 
   
 
 
 

訂閱最新消息:   © ASMedia Technology Inc. All Rights Reserved. ︱ 隱私權聲明 ︱ 聯絡我們